Skip to main content
This guide gives step‑by‑step instructions for installing and configuring PADS4 Viewer on Philips 5050D series displays.

​
Prepare the 5050D-series

Before installation, ensure that the PADS4 Server is set up and configured properly.
The minimum PADS4 Server version required is PADS4 Foundation 2025.1.
When turning on the device for the first time, the Configuration Wizard will appear. If not, reset the device as described in Resetting the Device.

​
Resetting the 5050D-series

If the device has been used before, perform a factory reset to clear the storage and avoid software conflicts.
  1. On the Philips remote control, press Home, then 1 8 8 8 to open the Android Menu.
  2. Open Settings, then select System Tools → Factory Reset.
  3. Confirm by clicking Factory Reset and pressing OK.
After the reset, the Welcome Screen appears. Continue with the steps in Configuring the Device.

​
Configuring the 5050D-series

  1. On the Welcome Screen, select your preferred language and click Start.
  2. On the Security Settings screen, ensure SICP Network Port is enabled. (Other settings can be enabled or disabled as required.)
  3. On the Network Settings screen, select and configure the network type.
  4. On the Signage Display Settings screen, press Skip.
  5. On the Clone Media Files screen, press Skip.
  6. Press Finish to complete the setup.

​
Checking Device Firmware

Ensure the correct firmware version is installed for full PADS4 Viewer functionality.
  1. Open the Android Menu by pressing Home 1 8 8 8.
  2. Open Settings → Select About.
  3. Ensure the Build Number is FB01.05 (required for PADS4).

​
Installing PADS4 Viewer

Follow these steps to install PADS4 Viewer on Philips D-line (5050D) displays.

​
Downloading the PADS4 Viewer

The PADS4Philips.apk file is available on the PADS4 Server in,
where [PADS4Server] should be replaced with the name of your server.
Locate the PADS4Philips.apk file and copy it to a USB stick

​
Installation Steps

  1. Insert the USB stick into the Philips 5050D-series.
  2. Open the Android Menu by pressing Home 1 8 8 8.
  3. Go to Apps → Settings → Security → More Security Setting.
  4. Enable Unknown Source.
  5. Return to the app screen.
  6. Open File Manager and select the USB stick.
  7. Open PADS4Philips.apk and tap Install.
  8. Tap Done

​
Configure automatic launch of PADS4

  1. Go to Settings → Signage Display → Source Settings → Custom Apps.
  2. Select PADS4 from the list of available applications.
  3. Enable Force Restart Custom App.
  4. Restart the screen to apply the changes.

​
Connect the PADS4 Viewer

After the device restarts, the PADS4 Viewer will appear.
  1. Enter the Server URL in the following format: https://[PADS4server]/[Domain].
  2. Replace [PADS4server] with the name of your server, and replace [Domain] with your domain. The default domain is PADS4.
  3. Fill in the ViewerName if required.
  4. Click Start to connect.
The PADS4 Viewer is now connected and ready for use.
You may see a message indicating that PADS4 is incompatible with this version of Android. This is due to the screen running a newer Android version. You can safely acknowledge and ignore this message. PADS4 is compatible with Android 14, and this warning will be resolved in a future release.