Skip to main content
This guide provides step-by-step instructions for installing and configuring PADS4 Viewer on Philips D-line (4550D) displays.

​
1. First-Time Use

Before installation, ensure that the PADS4 Server is set up and configured properly. 📌 Minimum PADS4 Server version required: PADS4 Foundation 2021.2 When turning on the device for the first time, the Configuration Wizard will appear. If not, reset the device as described in 1.2 Resetting the Device.

​
1.1 Configuring the Device

1

Step One

On the Welcome Screen, select your preferred language and click Start.
2

Step Two

On the Security Settings screen, ensure SICP Network Port is enabled. (Other settings can be enabled or disabled as required.)
3

Step Three

On the Network Settings screen, select and configure the network type.
4

Step Four

On the Signage Display Settings screen, press Skip.
5

Step Five

On the Clone Media Files screen, press Skip.
6

Step Six

Press Finish to complete the setup.
The device will display CMND & Deploy, an app supplied by Philips. No configuration is required for this app.

​
1.2 Resetting the Device

If the device was previously used, perform a factory reset to clear storage and prevent software conflicts.
1

Step One

Open the Android Menu by pressing Home, followed by 1 8 8 8 on the Philips remote control.
2

Step Two

Open Settings.
3

Step Three

Select System Tools → Factory Reset.
4

Step Four

Click on Factory Reset and confirm by pressing OK.
After resetting, the Welcome Screen will appear. Follow the steps in 1.1 Configuring the Device.

​
2. Installing PADS4 Viewer

Follow these steps to install the PADS4 Viewer on Philips D-line (4550D).

​
2.1 Checking Device Firmware

Ensure the correct firmware version is installed for full PADS4 Viewer functionality.
1

Step One

Open the Android Menu by pressing Home 1 8 8 8.
2

Step Two

Open Settings.
3

Step Three

Select About.
4

Step Four

Ensure the Build Number is FB01.04 (required for PADS4).

​
2.2 Updating Device Firmware

To update the firmware, follow the Philips instructions: 📌 Firmware update guide: Download Firmware Instructions
📌 Philips Download Center: Download Center

​
2.3 Installing PADS4Philips from USB Stick

The PADS4Philips.apk file can be found on the PADS4 Server in:
Alternatively, download the latest version from this link and place it in the apps directory on the PADS4 Server.

​
Installation Steps

1

Step One

Copy the PADS4Philips.apk file onto a USB stick.
2

Step Two

Insert the USB stick into the Philips D-line device.
3

Step Three

Open the Android Menu by pressing Home 1 8 8 8.
4

Step Four

Select Apps → File Manager.
5

Step Five

Open mnt → usb_storage and select PADS4Philips.apk.
6

Step Six

Select Install and then Open the app.

​
3. Supported Features & Limitations

​
4. Troubleshooting