Skip to main content
This guide provides step-by-step instructions for installing and configuring PADS4 Viewer on Philips Q-line (4650Q) displays.

​
1. First-Time Use

Before installation, ensure that the PADS4 Server is set up and configured properly.
The minimum PADS4 Server version required is PADS4 Foundation 2023.1.
When turning on the device for the first time, the Configuration Wizard will appear. If not, reset the device as described in 1.2 Resetting the Device.

​
1.1 Configuring the Device

1

Step One

On the Welcome Screen, select your preferred language and click Start.
2

Step Two

On the Security Settings screen, ensure SICP Network Port is enabled. (Other settings can be enabled or disabled as required.)
3

Step Three

On the Network Settings screen, select and configure the network type.
4

Step Four

On the Signage Display Settings screen, press Skip.
5

Step Five

On the Clone Media Files screen, press Skip.
6

Step Six

Press Finish to complete the setup.
The device will display CMND & Deploy, an app supplied by Philips. No configuration is required for this app.

​
1.2 Resetting the Device

If the device was previously used, perform a factory reset to clear storage and prevent software conflicts.
1

Step One

Open the Android Menu by pressing Home, followed by 1 8 8 8 on the Philips remote control.
2

Step Two

Open Settings.
3

Step Three

Select System Tools → Factory Reset.
4

Step Four

Click on Factory Reset and confirm by pressing OK.
After resetting, the Welcome Screen will appear. Follow the steps in 1.1 Configuring the Device.

​
2. Installing PADS4 Viewer

Follow these steps to install the PADS4 Viewer on Philips D-line (4650D).

​
2.1 Checking Device Firmware

Ensure the correct firmware version is installed for full PADS4 Viewer functionality.
1

Step One

Open the Android Menu by pressing Home 1 8 8 8.
2

Step Two

Open Settings.
3

Step Three

Select About.
4

Step Four

Ensure the Build Number is FB01.18 (required for PADS4).

​
2.2 Updating Device Firmware

To update the firmware, follow the Philips instructions: 📌 Download firmware + instructions from:
🔗 PPDS Philips Download Center

​
2.3 Installing PADS4Philips from USB Stick

The PADS4Philips.apk file can be found on the PADS4 Server in:
Alternatively, download the latest version from this link and place it in the apps directory on the PADS4 Server.

​
Installation Steps

1

Step One

Copy the PADS4Philips.apk file onto a USB stick.
2

Step Two

Insert the USB stick into the Philips D-line device.
3

Step Three

Open the Android Menu by pressing Home 1 8 8 8.
4

Step Four

Select Apps → File Manager.
5

Step Five

Open mnt → usb_storage and select PADS4Philips.apk.
6

Step Six

Select Install and then Open the app.

​
3. Supported Features & Limitations

​
4. Troubleshooting